Samsung RS261MD Series - 3-20) UPPER DUCT; 3-21) EVAPORATOR IN FREEZER; 4. TROUBLESHOOTING

32
3. DISASSEMBLY AND REASSEMBLY
Part name
Upper Duct
Descriptive PictureHow To Do
1. Remove the screws.
2. Remove the cover-evap
front.
3-20) UPPER DUCT
Part name
Evaporator In
Freezer
Descriptive PictureHow To Do
Evaporator is located in the bottom of
freezer to produce cold air driven across the
evaporator coils.
1. Take off the ductwork in Freezer.
2. Disconnect the wire connector (Heater,
Bimental, and Thermistor).
3. Desolder the inlet and outlet tubes.
5. Remove the evaporator.
4. Bend the suction pipe.
6. Take the same steps to seal the system as
mentioned earlier.
3-21) EVAPORATOR IN FREEZER
When diassembling, make
sure the unit is turned off
*
Reference (How To Do #4)
Caution
Accumulator
Thermistor
Bimetal
Sheath
Heater
suction
pipe