After Replacing the Panel
After replacing the panel, move to [Panel] and press and hold the Menu button for about 5 seconds.
Ch. No. (channel number) will increase by 1 each time the Menu button is pressed. Keep pressing the button until both
On Time and Cycle change to 0.
Monitor On Time : 0 Hr
Panel Ch. No. : 0
On Time : 0 Hr
Cycle : 10
Auto Auto : On
Pixelshift : Off
Country : English
Scaler-MCU : Novatek NT68650
Version : m-S119N0GFa-0900.0
Checksun : FE95
Service Function
Panel Ch. No.
This number is incremented by 1.
To Next Page
Loading...
