13
Setup
User’s Manual
1.Connect the power cord for your monitor to the power port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.
2.Connect the end of the signal cable to your computer's video port(video board,
video card or graphics card).
3.If you are using a Macintosh computer, connect the cable to a Macintosh adapter,
and set the pins on your adapter(Adapter not included). A PC-compatible computer does not
need an adapter.
4.Turn on your computer and monitor. If your monitor displays an image, installation is complete.
Connecting Your Monitor
To Next Page
Loading...
