COLOR CCD CAMERA User Guide
13
⓫
D & N Input Port : You can switch to Day & Night Mode by connecting an external signal to
this port.
⓬
MD Output Port : Motion detection signals are output through this port.
⓭
Ground Terminal
⓮
Video OUT Terminal :
Sends video signal and connects to the video input terminal of
the monitor.
⓯
Power LED : This lamp is lit when the camera is receiving power normally.
⓰
Power input terminal : Connects to the power appropriate to each model.
ö
External I / O port configuration
Num Name I/O Direction
1 RS-485+ I/O
2 RS-485- I/O
3 Freeze I
4 V-SYNC I
5-7 Shutter I
8DN I
9MD O
10 GND -
• When using the FREEZE Mode Setting Terminal, the Shutter Speed Select Terminal and
the D & N Input Port, Connect each of the terminals to the Ground Terminal.
Notes
To Next Page
Loading...
