r
Connecting to Monitor
Connect the Video OUT port on the rear panel of the camera to a monitor.
• As the connecting method varies with the instruments, refer to the manual supplied
with the instrument.
• Only connect the cable when the power is turned off.
CCD Camera Monitor
Connecting to Power
Since power specifications differ depending on the model, make sure to check your
model name and specifications before connecting power.
You can connect power as shown in the following figure.
For AC / DC power
• Since the power specification supports
both AC and DC, connect AC 24V,
500mA Adaptor or DC 12V, 500mA
Adaptor.
High Voltage Type (AC230V, 50Hz)
• Use AC230V, 50Hz power source For
SCB-3000/3001PH.
To Next Page
Loading...
