COLOR CCD CAMERA User Guide
24
Operating Your Camera
• When you use a DC lens, set the shutter mode to --- if color rolling occurs.
• When the SHUTTER is set to ESC after selecting the Internal Synchronization Type, the
picture may become unstable if the camera faces a bright fluorescent light. Therefore,
take care when choosing the installation position.
• When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.
•
When using an external input, Connect the Shutter Speed Select Terminal to the Ground Terminal.
Notes
- MANUAL : You can control shutter speed manually.
(NTSC MODEL - 1/60sec~1/120,000sec, PAL MODEL - 1/50sec~1/
120,000sec)
- A.FLK : Select this when you experience picture flicker, this happen when there is
a clash with the installed lighting frequency.
- EXTERN : Use the Shutter Speed Select Terminal on the back of the camera to
SHUTTER 1 SHUTTER 2 SHUTTER 3
1/60(1/50) OFF OFF OFF
1/120(1/100) ON OFF OFF
1/250 OFF ON OFF
1/500 ON ON OFF
1/700 OFF OFF ON
1/1000 ON OFF ON
1/1600 OFF ON ON
1/2500 ON ON ON
control the shutter speed via an external input. You can control the desired
speed as shown in the table below by connecting the terminal to the
Ground Terminal.
[ Interlace Mode]
AGC(AUTO GAIN CONTROL) : The higher the gain level, the brighter the screen - but
the greater the noise.
- OFF : Deactivates the AGC function.
To Next Page
Loading...
