12_ installation
INSTALLATION
Separate the dome cover by turning anti-clockwis.
Separate the shield case by pulling from the camera body.
1.
2.
The installation should be done by qualifi ed
service personnel or system installers.
If the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
To change the position of the cable, take
away the Hole Cover and pass the cable
through.
installation
Hole Cover
Original position of
the cable
※
To install the dome cover on the camera body, turn the latches in the locking direction as
shown in the figure 1.
Latch
Locking direction
[Figure1]
Locking direction
(Clockwise)
Main Body
(Camera)
Dome cover
Unlocking direction
(Anti-clockwise)
To Next Page
Loading...
