38_
connection & installation
connection & installation
EXAMPLE OF INSTALLING AN ENVIRONMENTAL MODEL
Fix the installation base with the bracket
Fix the base with the bracket by turning it clockwise.
As shown in the figure, lightly pull the hinge door handle in the side
end of the install base and lay it down. Please refer to the “Camera
Wiring Interface Board” on page 14, connect the wires.
Do not connect the camera to a power outlet until the installation is complete.
Supplying power while the installation is in progress may cause fi re or damage
the product.
Connect the camera safety wire to the installation base.
❖
1.
2.
J
3.
Safety Cable
To Next Page
Loading...
