Loosen 3 screws by turning them
counterclockwise, press both left and right
lock releases inwards (in arrow direction) to
unlock the stopper, and then separate the
camera from the case.
Drill holes (diameter 5mm, more than 35mm
deep) on the ceiling by matching to the holes
on the case bed, and insert plastic anchors
(HUD 5) fully into the holes. Fix the case bed
on the ceiling by using Tapping Screws (TH
M4xL30). (4 places)
Connect power and video cables and arrange cable running not to damage or
squeeze them, and assemble the camera unit in the reverse way.
Adjust the lens aiming to your desired direction.
Assemble the Dome Cover.
For waterproof purpose, fix and secure the bolt using L-wrench provided.
2.
3.
4.
5.
6.
To Next Page
Loading...
