Setting up the hardware_ 23
4. Pull out the OPC protecting pad.
If toner gets on your clothing, wipe it off with a dry cloth and wash clothing in cold water. Hot water sets toner into
fabric.
• Be careful not to scratch the surface of the imaging unit.
• To prevent damage, do not expose the imaging unit to light for more than a few minutes. Cover it with a
piece of paper to protect it if necessary.
5. Remove the tape.
6. Pull out the rubber stopper
install_guide_english.book Page 23 Saturday, July 21, 2012 4:53 PM
To Next Page
Loading...
