Initial settings and testing of the machine_ 37
5. Press Static and enter the IP address, subnet mask, and gateway in each input area using the pop-up keyboard or the
numeric keypad on the control panel. Then press Next.
• If a new IP address is assigned automatically by a DHCP or BOOTP, press DHCP or BOOTP.
• If you are not sure about your network environment, contact your network administrator.
6. Press the Name input area.
a. The pop-up keyboard appears.
b. The admin is entered as a default. If you want to replace with another name, remove admin and enter a new
administrator name and then press OK.
c. Press the New Password input area. The pop-up keyboard appears.
d. Enter the password to use and then press OK. This password is to be used for accessing the administrator
account.
e. Press the Confirm Password input area. The pop-up keyboard appears.
f. Re-enter the password to confirm it, then press OK and Next.
install_guide_english.book Page 37 Saturday, July 21, 2012 4:53 PM
To Next Page
Loading...
