Use the flash
Use A-TTL
mode
In
the A-TTL (Advanced Through The Lens) mode, an appropriate level
of
the flash is
automatically calculated based on the exposure value and shutter speed set on the
camera by measuring the light entering through the lens.
1 Connect the flash.
2 Power on the flash.
• Flash burst mode
is
set to
A-TIL
mode (Green lamp). If not, press [Mode] button and set
the mode to
A-TIL
mode (Green lamp).
3 Begin shooting after ensuring the flash is fully charged.
• When charging
is
complete, the Ready lamp will turn orange.
18
-
To Next Page