Disassembly and Assembly
71
Reassembly for Back Cover, Display, and Charging Port
Replacement
Before reassembling:
•
Remove the adhesive tape residues perfectly.
•
Prepare all existing screws of this device and adhesive tapes for the back cover and
front camera.
•
Wear an anti-static wrist strap and connect it to the grounded ESD safe mat.
•
Leaving screws inside the device may damage internal components, such as the
battery. When assembling, be extra careful not to leave any unassembled screws
inside the device.
•
The product’s composition may vary depending on the country, region, or carrier.
Preparing a New Display Module
1 Using the tweezers, remove the front camera hole protection film attached to the
new display module.
Be careful not to damage the near components.
To Next Page
Loading...
