31
INSERTING AND REMOVING A MEMORY CARD (NOT SUPPLIED)
1. Turn the camcorder off.
2. Open the memory card/jack cover as
shown in the diagram.
3. Insert a memory card into the memory
card slot until it softly clicks in the direction
of the arrow shown in the diagram.
4. Close the cover.
1. Turn the camcorder off.
2. Open the memory card/jack cover as
shown in the diagram.
3. Slightly push the memory card inwards to
pop it out.
4. Pull the memory card out of the memory
card slot and close the cover.
Your camcorder supports only SD(Secure Digital) and SDHC(Secure Digital High Capacity) cards.
Compatibility with this camcorder may vary depending on the card manufacturer and type.
To insert a memory card To eject a memory card
• If a memory card is not inserted correctly, the camcorder may fail to operate normally or the
memory card slot may be damaged.
• Be careful when ejecting a memory card. If the memory card is pushed hard, it may pop out suddenly.
To Next Page
Loading...
Need help?
General