installation & connection
16_ installation & connection
Installation
Use the provided screws (x3) to fix the bracket to a desired position (ceiling or wall).
Ensure that the <CAMERA FRONT> label on the bracket faces the direction for camera monitoring.
Arrange the cables through the bracket to
the ceiling or wall.
If you drill a hole in the ceiling cover for wiring, press
hard to remove the cover and attach the dust-proof
plate to it, and arrange the cables through the plate.
If you intend to arrange the cables without drilling a
hole, use the empty area opposite to the <CAMERA
FRONT> label side for the wiring purpose.
Mount the camera body onto the bracket.
Align the marking hole of the camera body
with the <CAMERA FRONT> label of the
bracket, and turn the body in the <LOCK>
direction.
Refer to “Adjusting the monitoring direction
for the camera” to adjust the lens in a desired
direction.
Close the top cover.
Fit the top cover into the fixing tips of the camera
body and turn the cover clockwise.
1.
2.
3.
4.
5.
Wiring Cover
To Next Page
Loading...
