installation & connection
44_ installation & connection
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply (SND-7084R)
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
If both PoE and DC 12V are applied simultaneously, the product will be supplied with power from
PoE.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
- It is advisable to use only one power source from PoE and DC 12V.
`
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
Power Supply (SNO-7084R/SNV-7084R)
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
If you turn on PoE and DC12V and AC24V at the same time, the first applied one will be used as
the power source.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
`
The heater will operate properly only by the power source of AC 24V.
- The heater does not work with DC 12V, PoE.
- Use AC 24V in a low-temperature place of less than -10°C.
`
Be careful not to reverse the polarity when you connect the power cable.
`
AC 24V can be connected in non-polar union.
`
If you want to connect an external device, you must turn off the external device before proceeding.
To Next Page
Loading...
Need help?
General
