User Manual
75
System Event Source
This sets some or all of disk error, disk full, fan error, authentication failure and DDNS
registration failure.
E-Mail Setup
E-Mail address is set when e-mail is used for output.
For e-mail address, enter an e-mail address for a message recipient.
The address format is xxxx@xxxxxx.xxx
. However, only Roman alphabet letters and numbers
are allowed.
- Sender Address
Sender Address is set when e-mail is used for output. The address format is
xxxx@xxxxxx.xxx
. You do not have to enter an e-mail address. In general, use an address
that identifies the e-mail as being sent from a specific DVR.
To Next Page
Loading...
