User Manual
91
6.9.1 System Setup
Language
The OSD menu supports multiple languages. Select a language.
Key Buzzer
This determines whether to use the buzzer for the buttons on the front.
Default
This restores the factory default settings. Press the [Default] button to restore the factory default.
Load Configuration
This sends the DVR setting stored in a USB storage device to the DVR.
Save Configuration
This saves the DVR setting to a USB storage device.
Firmware Update
Save the Update Firmware for USB to USB storage and connect it to the DVR.
Select Firmware Update from System Setup and press the [Enter] button.
When a message prompting you to update appears, select [Yes] and press the [Enter] button.
After a while, a buzzer beeps and the unit reboots.
The Update Firmware for USB is provided in a "*.dat" file.
To do a firmware update through the network, run the updater executable file and click a DVR
on the DVR list. When the IP, MAC address and port of the DVR are displayed, enter the
To Next Page
Loading...
