1. Connect the power cord to the DC adapter and then connect the adapter jack to the DC14V power
port on the monitor. (Voltage is automatically adjusted by the power adaptor.)
2. Connect the signal cable to the D-SUB port on the Macintosh computer.
3. For older model Macintoshes, you need to adjust the resolution control DIP switch on the Macintosh
adapter (optional) referring to the switch configuration table shown on its rear.
4. Turn on the monitor and Macintosh.
Contact a local Samsung Electronics service center to buy optional items.
4. Connecting Headphones
You may connect your headphones to the monitor.
1. Connect your headphones to the Headphone-out port.
User's Manual - 17
Setup-Connecting to Other Devices
To Next Page
Loading...
