adjust resolution, frequency or color and you cannot install the monitor driver.
1. Checking Adapter Driver
Click Start --> Settings --> Control Panel --> Display --> Settings --> Advanced --> Adapter.
If "Default" or a wrong product model is indicated, it means that the adapter driver is not properly
installed. Install the adapter driver again according to the information provided by the computer or
video card manufacturers.
2. Installing Adapter Driver
The instructions given below are for general circumstances. For specific issues, contact the
relevant computer or video card manufacturers.
1) Click Start --> Settings --> Control Panel --> Display --> Settings --> Advanced --> Adapter -->
Update Driver --> Next --> Display a list of the known drivers for this device so that I can
choose a specific driver --> Next -> Have Disk (Insert Video Card Driver diskette) -> OK -> Next
-> Next -> Finish.
2) In case you have Adapter Driver Setup file on your computer:
Run Setup.exe or Install.exe, which is found in the Adapter Driver Setup file.
4. For Better Display
1. Selecting Resolution and Color
If the monitor resolution or color is not properly set, the screen may show blurred images or mosaic
patterns.
2. Setting Refresh Rate
If the monitor refresh rate is not properly set, the screen image may be skewed or noise patterns will
appear. You can enjoy the best screen image when the refresh rate is set to 60 Hz.
Setting Refresh Rate >>
Click Start --> Settings --> Control Panel --> Display --> Settings --> Advanced --> Refresh Rate -->
Apply --> Yes --> OK --> Yes.
3. If the screen image is not acceptable or satisfactory, run AUTO ADJUSTMENT, to get a better
image quality, in the screen that appears immediately after you click Windows System End button. If
the noise persists even after AUTO ADJUSTMENT, adjust the screen settings using FINE/COARSE
tuning buttons.
Procedures for setting frequency in the Control Panel may vary depending on the video card.
Setting Color & Resolution >>
Click Start --> Settings --> Control Panel --> Display --> Settings --> Colors & Screen area -->
Apply --> OK.
You can get the best image quality by selecting resolution depending on the monitor screen
size as follows:
• 15 inch monitor : 1024 x 768 @60Hz
• 17 inch monitor : 1280 x 1024 @60Hz
Select 16 or 24 bit color.
• Supported or not subject to the video card (the monitor is irrelevant)
• LCD monitors may display up to 16.77 million colors (24 bits).
5. Dot Acceptable
TFT LCD panel manufactured by using advanced semiconductor technology with precision of 99.999%
above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright
User's Manual - 39
Troubleshooting-Check before Calling for Service
To Next Page
Loading...
