Samsung SyncMaster 400TSn-2 - Page 74

(Not available in Dynamic Contrast mode of On.)
Note
The direct button on the remote control is the 'AUTO' button.
Signal Balance
This is used to make up for the weak RGB signal transmitted by a long signal cable.
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-
ance]
(Available in PC mode only)
(Not available in Dynamic Contrast mode of On.)
Signal Balance
MENU →
→ ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-
ance] → ENTER → [Signal Balance]
→ , → ENTER
Selects either On or Off with the signal control.
Signal Control
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Balance]
→ ENTER →
→ [Signal Control]
1. R-Gain
MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal
Balance] → ENTER → → [Signal Control] → ENTER → [R-Gain]
→ , → ENTER
2. G-Gain
MENU →
→ ENTER → [Picture] → → → → → → → ENTER → [Signal
Balance] → ENTER → → [Signal Control] → → ENTER→ [G-Gain]
→ , → ENTER
Adjusting the LCD Display