Samsung SyncMaster 591s

1. Turn off
y
our com
p
uter and un
p
lu
g
the
p
ower cord.
2. Connect the end of the signal cable to your computer's video port(video board, video card or
g
ra
p
hics c ard
)
.
3. Connect one end of the other sound cable to the Mic Input jack on your sound card or
computer.Connect the other end of this cable to the Mic By-pass jack on the back of the
monitor stand.
4. Plu
g
the DC
p
ower cord from the stand into a nearb
y
outlet.
5. Connect the
p
ower cord for
y
our monitor to the
p
ower
p
ort on the back of the monitor.
6. Plu
g
the
p
ower cord for the monitor and the
p
ower cord for
y
our com
p
uter into a nearb
y
outlet.
7. Turn on
y
our com
p
uter and monitor.
8. Turn u
p
or down the On
-
Off control terminal on the stand of the monitor until it clicks.
9. Execute a sound program, music or sound effect in your computer and then adjust the volume
b
y
turnin
g
u
p
or down until the sound volume is a
pp
ro
p
riate.
10.
A
djust the treble and bass.
Sound distortion may occur when the monitor is placed on top of a mostly hollow cabinet such
as your computer. If this occurs, place a pad or magazine beneath the monitor stand. High
sound volume may also cause sound distortion; lower the volume.
Multimedia Speaker Stand
1. Mic By-pass Jack
To transmit your voice,connect a sound cable from
the Mic By-pass jack to the mic in jack on the sound
card slot in
y
our com
p
uter.
2. Stereo Input Jack
Connect a sound cable from the input source(sound
card
,
com
p
uter
,
CD
-
ROM driv e
)
.
3. DC Po wer Cord
Connect DC power cord to monitor DC 12V output
j
ack.
4. Power Indicator
Glows
g
reen when the s
p
eakers are turned on.
5. On/Off Volume
Turns On/Off and adjusts the output volume.
6. Treble Control
Use to control hi
g
h fre
q
uencies.
7. Bass Control
Use to control low fre
q
uencies.
8. Mic Input Jack
To transmit your voice,connect a microphone to this
j
ack.
9. Headphone Jack
To listen in privacy,connect headphones here.
10. Detachable Stand To
p