14
English
Connections
Connecting to an Antenna
When the TV is initially powered on, basic settings proceed automatically.
✎
Connecting the power cord and antenna.
ANT OUT
VHF/UHF Antenna
Cable
or
Antenna Cable
(Not Supplied)
Setup (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the POWER
P
button.
✎
Setup is available only when the Input Source is set to TV.
1
Selecting a language
Press the ▲ or ▼ button, then press the ENTER
E
button. Select the
desired OSD (On Screen Display) language.
2
Selecting Store Demo
or Home Use
Press the ▲ or ▼ button, then press the ENTER
E
button.
y Select the Home Use mode. Store Demo mode is for retail
environments.
y To return the unit’s settings from Store Demo to Home Use (standard):
Press the volume button on the TV. When you see the volume OSD,
press and hold MENU for 5 sec.
y Store Demo is only for shop display. If you select it, several functions
are not able to use. Please select Home Use when you watch at
home.
3
Auto Program Find and store channels on your TV.
Firstly, please select how you receive your programming
y I use an aerial cable to connect to TV. Memorise all of the available channels using RF cable.
y I use a set-top box. TV and set-top box are not connected by an aerial cable. So the customer does
not need to do the auto tuning steps.
✎
You can complete Setup by selecting it.
To run auto program, please select Next button. Then set the search options for anto tuning.
y If the antenna is connected to ANT 1 IN (AIR), select Air and if it is connected to ANT 2
IN (CABLE),
select Cable. After selecting the antenna source to memorize, select Next. The TV will begin
memorizing all of the available channels.
4
Setup Clock Set the Clock Mode automatically or manually.
y Auto: Allows you to select time zone.
y Manual: Allows you to manually set the current date and time.
y Select time zone you are in by pressing the
u
or
d
button.
Press the ENTER
E
button to confirm your choice.
✎
If the customer choose "Manual" set clock, this step doesn't display.
5
Complete
Press the ENTER
E
button.
If You Want to Reset This Feature...
MENU
m
→ System → Setup → ENTER
E
You should do Setup again at home although you did in shop.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets the PIN to “0-0-
0-0”: POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).
Connections
To Next Page
Loading...
