Samsung T260

0#&&4+@#.:65&&&4+@+&&4?#$.&45&06%&4+@#.&4
5&&?:6&&0
0#&%&&4
2-1) Using the D-sub (Analog) connector on the video card : Connect the signal cable to the 15-pin, D-sub connector on
the back of your monitor.
2-2) Using the DVI (Digital) connector on the video card : Connect the DVI cable to the DVI port on the back of your monitor.
2-3) Connecting to Macintosh : Connect the signal cable to the 15-pin, D-sub connector on the Macintosh.
(0*6:6#5+6&5&0.:65&'+:'5%'&&'#5+&0
※ You may get a blank screen depending on the type of video card you are using, if you connect simultaneously both the D-Sub
and DVI cables to one computer.
※ If you properly connect your monitor using the DVI connector but get a blank screen, check to see if the monitor status is set
to
analog. Press Source Button to have the monitor double-check the input signal source.
4. T260 / T240 Connect i on ( 1)
4. T260 / T240 Connect i on ( 1)