Samsung T260

12. Ser vi ce ( Hot key) Funct i on l i s t
12. Ser vi ce ( Hot key) Funct i on l i s t
( 4)
( 4)
-. HDCP Hotplug : used when HDCP Video contents are not displayed. In case that monitor is
connected to some bad device which does not comply with standard.
-. HotPlug Time : If Hotplug is turn on, when monitor power off/on or changing to the DVI, hotplug
pin goes to the low. This function controls this time duration.
Though Hotplug is turn on monitor can’t displayed, adjust this time duration
-. Default is 5(means 0.5 sec), can control 5 to 50.