Server Network Settings
MENUm → Network → Server Network Settings → ENTERE
Connect to server
To run Player connect to a network.
•
If the SSL option is enabled, the server is configured to use https and data transfer is encrypted.
―
Enter the server IP address and port number. Use 7001 as the port number. (If unable to connect to
the server using port number 7001, check with your server administrator to find the correct port
number and then change the port number.)
MagicInfo Mode
Select the appropriate MagicInfo Mode depending on the environment where you are using the
product.
•
MagicInfo
Server Access
Select a method to connect the server network.
•
Allow / Deny
FTP Mode
Specify the FTP operating mode.
•
Active / Passive
Device Name
MENUm → Network → Device Name → ENTERE
Select or enter a device name.
This name can be shown on network remote controls over the network.
To Next Page
Loading...
