Anynet+ (HDMI-CEC} Setup
Screen Menu > System > Anynet+ (HDM_-CEC} ,}:::!_:11:::i::
Enable/disable Anynet+ (HDMI-CEC).
o Anynet+ (HDMm-CEC}: Enables/disables Anynet+ (HDMI-CEC). Disabling this turns off all
Anynet+-related features.
Auto Turn Off: Turns off external devices when the TV is turned off. Some devices do not support
this option.
Receiver: Listen to audio through an AV receiver instead of the TV speakers. This option is only
available when there is an AV receiver connected to the TV.
Using the Anynet+ (HDMm-CEC}
You can operate external devices using just the TV remote control.
Switchin9 between Anynet+ Devices
2_
Select the Virtual Remote panel's or the regular remote's TOOLS button to display the list. Select
Anynet+ (HDM_-CEC} from the list. A device selection screen will appear.
Select a device and wait for the switch to take place. This process may take up to 2 minutes to
complete and cannot be cancelled when started.
Alternatively, switch to a different Anynet+ (HDMI-CEC} device by select ng ts name from the Source Ist,
However: Anynet+ (HDMI-CEC} cannot be used if a connected input connector' is se ected,
To Next Page
Loading...
