Setting the Time and Using the Timer
Setting the Current Time
MENU > System > Time > Clock
Try Now
Set the clock manually or automatically. Once the clock has been set, you can select the virtual remote
panel's INFO to check the current time.
"
The clock must be reset every time the power is disconnected.
Setting the Clock using Digital Broadcast Info
MENU > System > Time > Clock > Clock Mode
Try Now
Set Clock Mode to Auto. The TV automatically downloads the correct time from a digital channel. To
enable this option, the TV's Antenna jack must be connected to either an antenna or a cable output
and must be receiving digital broadcasts. The accuracy of the time information received may vary
depending on the channel and signal. If your TV is connected to a set-top-box or satellite box using
HDMI or Component connections, you must set the time manually.
If the Clock is Wrong in Auto Mode...
MENU > System > Time > Clock > Time Offset
Try Now
If the time set automatically is incorrect, you can offset the clock in 1-hour increments by as much as
-/+ 12 hours. Select System > Time > Clock > Time Offset and offset the clock to the correct time.
"
Time Offset adjusts the time through a network connections and is only available if the Clock Mode is set
to Auto and the TV is connected to the Internet though a local area network.
"
Time Offset will adjust the time if the TV fails to receive time information through normal digital broadcast
signals.
Setting the Clock Manually
Manually enter the time. Set Clock Mode to Manual and then select Clock Set to enter the current
time and date.
Clock Set: Set the current Date and Time.
To Next Page
Loading...
