Securing the TV to the Wall
Caution:
Pulling, pushing, or climbing
on
the
1V
may cause the
1V
to fall.
In
particular, ensure your children
do
not hang over or destabilize the 1V; doing so may cause the
1V
to tip
over,
causing serious injuries or
death. Follow
all
safety precautions provided on the included Safety
Flyer.
For added stability, install the
anti-fall device for safety purposes, as follows.
Accessories
1V-Holder
Screw (M4Xl12)
To
prevent
the
TV
from
falling
1.
Remove the screw attached to the back of your
1V,
then connect the 1V-Holder to the
1V
with the screw.
~
Make sure to only use the supplied screw.
~
When you install the wall-mount, refer to the "Securing the TV to the wall"
in
the TV manual for installation type.
1----------'
I
CQ::~
0 I
~CJI
2.
Firmly fasten the screw to the wall or cabinet where the
1V
is
to be installed. Tie the 1V-Holder attached to the
1V
and the
screw fastened
on
the wall or cabinet so that the
1V
is
fixed.
~
Only the screw needed to attach the holder to the TV is supplied. The screw to attach the Holder to the wall or
cabinet must be purchased separately.
We
recommend purchasing a size M4xL20 wood screw.
~
Install the TV close to the wall so that it does not fall.
~
When attaching the TV to the wall, tie the cord level with the ground or slanted downwards for safety purposes.
~
Check the cord occasionally to make sure
it
is
secure.
~
Before moving the
TV,
separate the connected cord first.
3.
Verify
all
connections are properly secured. Periodically check connections for any sign
of
fatigue or failure.
If
you have any
doubt about the security of your connections, contact a professional installer.
To Next Page
Loading...
