Samsung WA40A3 A Series - Page 50

50 English
Troubleshooting
Troubleshooting
No Code Meaning
6
High LED
Flashes
Your Washer has tried to ll but has not reached the proper
water level.
NOTE
When the High LED is ashing, the washer drains for 3 minutes.
During this time, the POWER button is inoperative.
• If the information code remains, contact a customer service
center.
7
Mid LED
Flashes
A fault is detected in the water level sensor.
If the information code remains, contact a customer service
center.
8
Low LED
Flashes
Your washer is not draining. It can also mean that the unit
senses a small clog while draining.
• Do the following:
1. Turn off the unit and turn it on again.
2. Select only the Spin Only.
3. Press the START/PAUSE to drain the water. If it still does not
drain, contact a customer service center.
9
Hot & Warm
LEDs ash
Unbalanced load prevented your Washer from spinning.
• Redistribute the load, and then press the START/PAUSE
button.
10
Hot & Cool
LEDs ash
Motor not running properly.
• Restart the cycle by presssing the START/PAUSE button.
• If the information code remains, contact a customer service
center.
11
Hot & Cool
LEDs ash
Mems sensor is not working properly.
• If the information code remains, contact a customer service
center.
12
Hot & Extra
High LEDs
ash
Door lock is not working properly.
• Close the lid tightly and restart the cycle.
• If the information code remains, contact a customer service
center.
WA3000A_DC68-03850F-00_EN.indd 50WA3000A_DC68-03850F-00_EN.indd 50 2020-12-07  4:21:062020-12-07  4:21:06