English 49
Troubleshooting
Information codes
The washer may display information codes to help you understand what is occurring with
your washer better.
No Code Meaning
1
Hot LED
Flashes
Lid is open when washer is running.
• Close the lid tightly and restart the cycle.
• If the information code remains, contact a customer service
center.
2
Warm LED
Flashes
Communication error between SUB PBA and MAIN PBA.
• If the information code remains, contact a customer service
center.
3
Eco Warm
LED Flashes
A button is not working properly.
• If the information code remains, contact a customer service
center.
4
Cool LED
Flashes
The Water Level sensor is not working properly.
NOTE
When the Cool LED is ashing, the washer drains for 3 minutes.
During this time, the POWER button is inoperative.
• If the information code remains, contact a customer service
center.
5
Extra High
LED Flashes
Your Washer has tried to ll but was unsuccessful.
NOTE
When the Extra High LED is ashing, the washer drains for 3
minutes. During this time, the POWER button is inoperative.
• Make sure the water faucets are open all the way. Check for
kinked hoses.
• Check the inlet screens on the ll hoses.
• If you use a Flood Safety Device, remove the device and
connect the water hoses directly to the unit.
Check if the hot water supply hose is connected.
• You must connect the hot water supply hose because hot
water is supplied by the Auto Temperature Control (A.T.C.)
function.
WA3000A_DC68-03850F-00_EN.indd 49WA3000A_DC68-03850F-00_EN.indd 49 2020-12-07 4:21:062020-12-07 4:21:06
To Next Page
Loading...
