English 25
Installation
STEP 4 Leveling your washer
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
3. If the washer is level, the pulsator (A) is
positioned at the center of the water as
shown in the gure.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary.
NOTE
Turn the front leveling feet clockwise (B) to
lower the washer, and counterclockwise (C)
to raise the washer.
WA3400T_DC68-03850E-04_EN.indd 25WA3400T_DC68-03850E-04_EN.indd 25 2021-01-29 12:42:312021-01-29 12:42:31
To Next Page
Loading...
