34_ troubleshooting
High current detected. Restart the cycle.
If the code reappears, call for service.
Too much suds has been
detected during the washing
cycle.
The unit pauses until the suds
dissapate. Then, the unit will go
back into operation.
When it fi nishes washing, End and
the SUdS code will blink in turn.
To prevent, reduce the amount of detergent.
A fault is detected by the water
level sensor.
Call for service.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
WA484DSHA-03050D_EN.indd Sec8:34WA484DSHA-03050D_EN.indd Sec8:34 2012-07-02 3:39:292012-07-02 3:39:29
To Next Page
Loading...
