Samsung WA48H7400AP - Page 15

Disassembly and Reassembly _ 13
Part Figure Description
Top Cover Assembly
/ Door Switch
1. Remove the 2 screws from the cover
plate.
2. Separate the control panel assembly.
3. SeparatetheAssyValveWater,themain
PBA,theAssySensorPressureandthe
lterEMIhousing.
Separate the housing to prevent
stress and damage to the wire-
harness.
4. Separatethemainwireharness,the
pressureswitchhoseclip,Grounding
screw .
5. Release the bleach hose clamp.
6. Separate the top cover assembly by
lifting and pushing ahead the top part of
the assembly.
7. you can check the door switch If turn the
Top cover upside down.
Sensor Pressure
Switch
1. Disassemble the control panel assembly.
2. Separate the pressure switch housing.
3. Beforeseparatingthehose,releasethe
clip.
 Whenreleasingtheclip,takecare
that you do not tear the hose.