16 _ Disassembly and Reassembly
Part Figure Description
Clutch Assembly
(continued)
6. Remove the shaft with the jig wrench.
- Release the nut in a clockwise direction.
- Fasten the nut in a counterclockwise
direction.
7. Place the main body so that the front
frame faces upward and remove the 4
bolts holding the saddle with a 10mm
wrench.
When you place the washer on
theoor,takecarethatyoudonot
damage or scratch the product.
8. Remove the bolt holding the DD-motor
housing with a 17mm wrench and then
remove the motor housing.
9. Remove the 6 bolts holding the DD-
motor with a 10mm wrench.
To Next Page
Loading...
