INFORMATION CODES
The Washer may display information codes to help you understand what is occurring with your Washer better.
The Water Level sensor is not
!ll_ working properly.
Your Washer has tried to fill but
was unsuccessful.
Check if the hot water supply
hose is connected
Your Washer has tried to fill but
Call for service.
Your washer is not draining. It can
also mean that the unit senses a
small clog while draining.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function.
Do the following:
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Call for service.
IC
IIm |_ has not reached the proper water
level.
e! Unbalanced load prevented your
l!__.tL--" Washer from spinning.
o!l_ Lid is open when washer is
!_l_ running.
C Your washer failed to look the lid.
!J
The door will not unlock.
LLt
Jammed
Key.
Motor not running properly.
I_,ItW Communication error between
NIX SUB PBA and MAIN PBA
Redistribute the load, press the Start/Pause
button.
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Make sure the lid is firmly closed.
Push the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
Call for service
Restart the cycle pressing the Start/Pause
button. If the code reappears, call for service.
Call for service.
troubleshooting 33
To Next Page
Loading...
