Samsung WA5451AN Series - Step 3: Leveling Your Washer; Step 4: Powering Your Washer; Step 5: Running a Test Cycle

16 _ Disassembly and Reassembly
Part Figure Description
Clutch Assembly
(continued)
6. Remove the shaft with the jig wrench.
-Releasethenutinaclockwisedirection.
-Fastenthenutinacounterclockwise
direction.
7. Place the main body so that the front
frame faces upward and remove the 2
bolts holding the saddle with a 10mm
wrench.
When you place the washer on
theoor,takecarethatyoudonot
damage or scratch the product.
8. Remove the bolt holding the DD-motor
housing with a 17mm wrench and then
remove the motor housing.
9. Remove the 6 bolts holding the DD-
motor with a 10mm wrench.
Hudson Washer.indb 16 2012-03-28 �� 9:45:54