What to do if my Samsung Washer does not start?
If your Samsung Washer isn't starting, here are a few things to check: * Ensure the door is completely closed. * Verify that the water taps are open. * Press the Start/Pause button. * Confirm that Child Lock is not activated. * Be aware that the machine may enter Standby, pause, or be in a soaking cycle, so please wait. * Also, the washer makes clicking noises and does a quick drain before filling.
How to fix a Samsung WA7200 Washer that does not turn on?
If your Samsung Washer isn't turning on, try the following: * Ensure your home electrical system provides the correct power. * Make sure the power cord is fully plugged in. * Check the fuse or reset the circuit breaker. * If you turned off the power to drain water from the Active Waterjet function, the power won't turn on until the water is completely drained.
Why is my Samsung WA7200 Washer leaking water?
If your Samsung Washer is leaking water, consider these potential solutions: * Ensure all hose connections are tight. * Check the rubber washers in the water supply hoses and tighten the hoses. * Make sure the drain hose is correctly inserted and secured. * Avoid overloading the machine. * Use high efficiency (HE) detergent. * Make sure the water supply hose is not kinked. * If the water supply pressure is too strong, close the water tap a little. * Also, check the water tap for leaks and repair if necessary.
Why Samsung Washer does not drain and/or spin?
If your Samsung Washer isn't draining or spinning, try these steps: * Check the fuse or reset the circuit breaker. * Ensure the electrical voltage is normal and the washer is plugged in. * Make sure the drain hose is pointed downward (for natural drain models only) and is not clogged or kinked. Straighten the drain hose. * Close the door and press Start/Pause, as the washer won't spin unless the door is closed.
What to do if the door of my Samsung Washer is locked?
If the door or lid of your Samsung Washer is locked or won't open, try these steps: * Press Start/Pause to stop the washing machine. * Allow a few moments for the door lock mechanism to disengage.
Why is water not being supplied to my Samsung WA7200?
If water is not being supplied to your Samsung Washer, consider the following: * Make sure you press Start/Pause after selecting the cycle and options. * Ensure the water taps are open. * Clean the mesh filters in the water inlets with a toothbrush if they are clogged. * Check if the water supply is cut off; if so, close the tap and power off the washer. * Straighten the water supply hoses. * Open and close the door, and then press Start/Pause. * Note that low water pressure can increase the time it takes to start washing. * Adjust the water level using the level selector if it's lower than expected.
Why does my Samsung Washer keep stopping?
If your Samsung Washer stops mid-cycle, consider these potential causes: * Ensure the washer's power cord is fully plugged in and the circuit is live. * Check the fuse or reset the circuit breaker. * Close the door and press Start/Pause, as the washer won't spin unless the door is closed. * There may be a pause or soak period in the cycle, so wait briefly. * Make sure the inlet hose filters at the taps are not clogged, and clean them periodically. * Low voltage in your electrical system may also cause this issue; it should resolve when the voltage returns to normal.
How to prevent excessive suds in my Samsung WA7200 Washer?
If you're experiencing excessive suds in your Samsung Washer, here's what to do: * Use high efficiency (HE) detergent to prevent oversudsing. * Reduce the detergent amount for soft water, small loads, or lightly soiled loads. * Do not use Non-HE detergent.
Why is my laundry load still wet after a Samsung WA7200 cycle?
If your laundry load is still wet after a cycle in your Samsung Washer, here are some things to consider: * Use the High or Extra High spin speed cycle (if your model has it). * Use high efficiency (HE) detergent to reduce oversudsing. * Be aware that small loads (one or two items) may become unbalanced and not spin completely.
Why does water drain out immediately from my Samsung WA7200?
If water drains out of your Samsung Washer immediately, check these: * Ensure the drain hose is not clogged and is hung over the drain hose hook. Fill the spin basket halfway with water, and try spinning again. * Lift the end of the drain hose to prevent water from draining. Fill the spin basket halfway with water, and then run the Spin cycle after releasing the drain hose. * Make sure the drain hose is installed correctly and adjust its position as instructed.
To Next Page
General
