Samsung WA75C - HDMI-CEC issues

62
HDMI-CEC issues
Anynet+ does not work. Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
Check if the Anynet+ device power cord is properly connected.

Check whether Anynet+ (HDMI-CEC) is set to On in SettingAdministativeControl
Check whether the remote control is Anynet+ compatible.

If you have removed and then reconnected the HDMI cable, please make sure to search
devices again or turn your product off and on again.
Check if the Anynet+ function of the Anynet device turns on.
I want to start Anynet+. Check if the Anynet+ device is properly connected to the product and check if Anynet+
(HDMI-CEC) is set to On in MenuSETTINGSExternal Device Manager.
I want to exit Anynet+. Press the SOURCE button on the product remote control and select a non-Anynet+ device.
The message “Disconnecting Anynet+ device...”
appears on the screen.

mode.


The Anynet+ device does not play. You cannot use the play function when initial setup is in progress.