Prevention of afterimage burn-in
What is afterimage burn-in?
Afterimage burn-in should not occur when the panel is operating normally. Normal operation
extended period of time a slight voltage difference may occur between the electrodes in
pixels that control the liquid crystals.
Such a voltage difference between electrodes increases with time and makes the liquid
crystals thinner. When this occurs, a previous image can remain on the screen when the
pattern changes.
for an extended period of time may cause afterimage burn-in. This problem is not
included in warranty.
Recommended prevention practices
smudges. Turn off the product when it is not used for a long time, activate the Power Saving
mode, or run a moving screen saver.
HDMI License notice
the HDMI Logo are trademarks or registered trademarks of HDMI
Licensing Administrator, Inc. in the United States and other countries.
Open Source License Notice
Open Source used in this product can be found on the following webpage
https://opensource.samsung.com
To Next Page
Loading...
