Samsung WD0804W8E - Drain Only Fuction; My Cycle

26_ washing a load of laundry
DrainOnlyFuction
When you want just drain water from washing machine, follow directions below.
1. Press the Power button.
2. TurntheCycleSelectortotheSpinposition.
3. Press the Spinbuttonrepeatedlyuntil“Nospin( )”lightcomeson.
4. Press the Start/Pause button.
Mycycle
Allowsyoutoactivateyourcustomwash(temperature,spin,soillevel,etc.)withonebutton
convenience.
By pushing the My Cyclebutton,presstheMyCyclebuttontoloadandusethesavedMy
Cycleoptions.Thechosencourseandoptionlightswillicker.
YoucansetalloptionsasfollowsintheMyCyclemode.
1. Turn the water supply on.
2. Press the Power button.
3. Select cycle using the Cycle Selector.
4. After cycle selection, set each option.
Seethe“CycleChart”onpage41foravailableoptionsettingswitheachcycle.
5. You can then store the selected cycle and options by pressing and holding the My Cycle
buttonforlongerthan3secondsinMyCyclemode.Thecycleandoptionsyouselectwillbe
displayedthenexttimeyouchoosetheMyCyclefunction.
YoucanchangetheMyCyclesettingsbyrepeatingthesameprocessabove.
ThelastusedsettingwillbedisplayedthenexttimeyouchoosetheMyCyclefunction.
IfyoupressMyCycleandreleaseitwithin3seconds,thepreviouslysavedcourseand
optionsappear.IfyoupressandholdMyCyclefor3secondorlonger,thecurrentlyset
courseandoptionsaresavedandtheLEDblinksfor3seconds.
washing a load of laundry
WD0804W8-02927U_EN(XEU)_removePF.indd 26 2011-7-9 11:58:57