Samsung WD10 K6 /X Series - Page 27

Disassembly and Reassembly_25
Partname Description Figure
Removing
theDuct
(Replacing
theDry
Motor)
3.Removethescrew.
√CheckPointsforTroubleshooting
1.RevolvethedrymotormanuallyandcheckwhetherSpinthedrymotor
manuallyandcheckthatitrotatesfreely.
2.Measuretheinternalresistance(betweenthewhiteandbluewiretermi-
nals)
→severalΩ:short-circuited,∞:disconnected
Removing
theDuct
(THERMO-
STAT)
1.Removetheconnector.
Removethejacksconnectedto
thethermostatandremovethe
four(4)screws,asshowninthe
gure.
√CheckPointsforTroubleshooting
● Measuretheresistancebetweenbothendsofthethermostat:0Ω
→Ifthestudisraisedduetooverheatinganditispressed,itwillbere-
turnedtotheoriginalpositionwitha‘snapping’sound.
Removing
theDuct
(THERMIS-
TOR)
1.Removethetwo(2)screws
connectedtothedryductand
removethewhitethermistor.
WD6500K_7-8-9-11kg_1400rpm-SM.indb 25 2018/11/9 9:53:18