Samsung WD10 K6 /X Series - Page 30

28 _Disassembly and Reassembly
Partname Description Figure
WASH
HEATER
1.SeparatetheBackCover.
2.SeparatetheConnectionHous-
ing(4).
3.Removethenutholdingthe
heaterandseparatetheHeat-
er.
4.RemovetheHeaterfromthe
Tub.
Caution
MakesuretoinserttheHeaterintothe
correctpositionofthebracketinsidethe
Tubwhenreassemblingit.Otherwise,thereisadangerofare.
Makesuretopushitinwardsuntilthepackingpartcomesinto
theTubcompletelywhenreassemblingitsothatthepacking
partiscompletelystucktotheTub.Fastentheholdingnutwitha
forceof5Kgf/cm2.Ifthenutisnotfastenedproperly,thereisa
dangerofwaterleaking.
WD6500K_7-8-9-11kg_1400rpm-SM.indb 28 2018/11/9 9:53:25