English
Installation
English24
CAUTION
Do not stretch the water hose by force. If the hose is too short, replace the hose with a longer, high-
pressure hose.
Connecting to a non-threaded water tap
1. Remove the adaptor (A) from the water hose (B).
2. Use a Phillips screwdriver to loosen four screws on
the adaptor.
3. Hold the adaptor and turn part (C) in the arrow
direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and then
tighten the screws while lifting the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
U-PJT_COMBO-MD_SimpleUX_DC68-04269L-00_EN.indd 24 2021/6/30 9:07:03
To Next Page
Loading...
