To Add Laundry ( )
1. Press the [Stop&Add] button.
• The washing machine will automatically pause to operate.
2. Wait about 30 seconds and check the [Stop&Add] button for the lamp state.
• Blinking: the machine drains water down to the safety level so it can get an additional quantity
of laundry (displayed in pause mode)
• Off: adding the laundry is possible.
The washing machine detects the internal quantity of laundry about 30 seconds before deciding
whether it could get more laundry.
3. Add the laundry.
4. Press the [Start / Pause] Button.
• Avoid adding the laundry when the machine has foamed up or is filled with water.
Otherwise, the foam or water may leak out of the door. So check it first before opening the
door.
Using Clean Tub
Is a course for washing the tub.
1. Press Power button.
2. Select the Clean Tub Course by turning the dial of Course Select.
3. Put an adequate amount of bleaching agent in the detergent tray ( ) for Main Laundry.
(See “Washing for the first time”.)
: You’d better use a powder-type detergent for more efficient washing.
If you want to wash it lightly : You may wash it just by selecting the 40°C-Water without bleaching
agent.
4. Press Start/Pause button.
Notice : About one time a month is enough for the tub-washing.
Washing a Load of Laundry
To Next Page
Loading...
