English 21
Installation
2. Use a Philips screwdriver to loosen four
screws on the adaptor.
C
3. Hold the adaptor and turn part (C) in the
arrow direction to loosen it by 5 mm (*).
4. Insert the adaptor into the water tap,
and tighten the screws while lifting up
the adaptor.
5. Turn part (C) in the arrow direction to
tighten it.
E
6. While holding down part (E), connect the
water supply hose to the adaptor. Then,
release part (E). The hose ts into the
adaptor with a clicking sound.
WD80J6A10AW_DC68-03628L_EN.indd 21 2017/12/5 17:17:08
To Next Page
Loading...