English 25
Before you start
Before you start
Initial settings
Run Calibration (recommended)
Calibration ensures accurate weight
detection by the washing machine. Make
sure the drum is empty before running
Calibration.
1. Power off, and then power on the
washing machine.
2. Hold down Temp. and Delay End
simultaneously for 3 seconds to enter
Calibration mode. The “CB” message
appears.
3. Press Start/Pause to run the Calibration
cycle.
4. The drum will rotate clockwise and
counter-clockwise for about 3 minutes.
5. When the cycle is complete, “0” appears
on the display and the washing machine
will turn off automatically.
6. The washing machine is now ready for
use.
WD80J6A10AW_DC68-03628L_EN.indd 25 2017/12/5 17:17:09
To Next Page
Loading...