fills with the wrong
:emoera:ure wa:er.
aoo" locked or v/ill not
ooen,
aoes rot drain and!or spin.
load is too wet at the end of
:ne cycle.
leaks wa:er.
nas excessive suas.
• Turn both faucets on fully.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct faucets.
Flush water lines.
• Disconnect the hoses and clean the screens. The hose filter screens
may be clogged.
• As your Washer is filling, the water temperature may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
• While your Washer is filling, you may notice just hot and/or just
cold water going through the dispenser when cold or warm wash
temperatures are selected. This is a normal function of the
temperature control feature as your Washer determines the
temperature of the water.
• Press the Start/Pause Button to stop your Washer.
• It may take a few moments for the door lock mechanism to
disengage.
• Check the fuse or reset the circuit breaker.
• Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
restriction, call for service.
• Close the door and press the Start/Pause Button. For your safety,
your Washer will not tumble or spin unless the door is closed.
• Use the High or Extra High spin speed.
• Use high efficiency detergent to reduce over-sudsing.
• Load is too small. Very small loads (one or two items) may become
unbalanced and not spin out completely.
• Make sure the door is firmly closed.
. Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and secured
to the drainage system.
• Avoid overloading.
• Use high efficiency detergent to prevent over-sudsing.
• Use high efficiency detergent to prevent over-sudsing.
. Reduce the detergent amount for soft water, small or lightly soiled
loads.
• Non-HE detergent is NOT recommended.
troubleshooting 19
WF209ANW-02440F EN.indd 19 2009-01-20 _;._E._ 4:05:16
To Next Page
Loading...
