troLAbesho©tnG
High/Low voltage detected.
SilverCare TM control problem
I Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
To prevent it, cut down on detergents.
For any codes not listed above, call 1-800-726-7864 (1-800-SAMSUNG)
To Next Page
Loading...
