Denition of Board Input Test Mode:
- Board Input Test Mode is to display a specied input after a key press.
How to Enter:
- To enter the Board Input Test Mode, press the Extra Wash key during Service Mode.
(same for all Frontier 2 models.)
Board Input Test Mode:
1. Activate the Service Mode rst.
2. Press the Extra Wash key to start Board Input Test.
3. Water Temperature Display in Celsius Dial the Rotary Cycle Selector to “Heavy Duty” and press the Start/Pause dial.
4. Water Temperature Display in Fahrenheit Dial the Rotary Cycle Selector to “Normal” and press the Start/Pause dial.
5. Door Position (Open/Close) Display Dial the Rotary Cycle Selector to “Whites” and press the Start/Pause dial: “OP” will illuminate if open,
“CL” if closed.
6. Door Status (Lock/Unlock) Display Dial the Rotary Cycle Selector to “Perm Press” and press the Start/Pause dial: “UL” will illuminate if
unlocked, “LO” if locked.
7. Water Level Display (Frequency) Dial the Rotary Cycle Selector to “Quick Wash” and press the Start/Pause dial:
If it illuminates “2435”, it indicates 24.35 kHz.
8. AG Kit Status Dial the Rotary Cycle Selector to “Sanitize” and press the Start/Pause dial.
Then, it will display the Ag Kit Status in 3 seconds: “- -” if AG kit is operated properly.
“7E” if AG kit is out of order (check wire harness & PCB)
4-2-9. Board Input Test Mode
To Next Page
Loading...
